Here are several views of the latest iteration of the 3D model I'm developing of the tying joint used in the Hawkins house frame. This joint is used to fasten each post to its respective tie-beam end, forming the bents, and then subsequently tie the bents themselves together via the front and back top plates, thus forming the basic, standing frame of the house.
The image below shows a typical post top, which is joined to its tie-beam via a tiesel tenon. I still need to determine if the tenon actually extends all the way back to the (non-tapered) end of the post, or if it stops just short of the post end (this is one of the least accessible areas of the post, as it faces the exterior sheathing):
The next image shows the corresponding tie-beam end. A large 3x8x9 shoulder cut out of the bottom of the tie-beam supports the 6x9 plate, which in turn has a mortise that accomodates the 2x8x9 tenon projecting horizontally from the end of the tie-beam, just above the shoulder. Plate and tie-beam are drawn together via a single 1 1/2" peg, pounded in from above. There is also a smaller hole to accomodate the end of the peg securing the rafter foot where it is stepped on to the plate. A mortise cut into the bottom of the shoulder, and extending partly into the tie-beam just beyond the shoulder, accomodates the post's tenon:
Note that, if the post tenon actually does indeed extend all the way to the back of the post, then this mortise is most likely opened at the end of the shoulder. I haven't determined yet if this is actually the case, but this is how I've modeled it for now. I also need to determine if the mortise is blind or open on top. Again, all this is difficult to discern, because this part of the joint is almost completely inaccessible to nondestructive probes.
The next image shows the tie-beam end, as viewed from below. There is a pronounced, adzed reduction in the bottom of the tie-beam, which, on average, extends about 9" inward from the inside edge of the mortise, and is about 1/2" deep:
Here is the tie-beam end, as it would appear facing head-on. An odd characteristic of the mortise, visible from this perspective, is that the blind part of the mortise, just beyond the shoulder, extends upwards an additional 1 3/4", despite the fact that the tenon itself has been measured as only 2 3/4" in length at this end. There is no obvious reason why the blind part of the mortise is cut much deeper than what the tenon actually requires:
Below is yet one more image of the tie-beam end, as viewed along its length:
And here's a photo of an actual Hawkins house tie-beam and post joined together. The plate, of course, is just beyond the wall and ceiling, so not visible in this photo:
The layout of this tying joint might very well be a vernacular design of the Second or Third Period of the New Haven Colony. It's a much simpler geometry than the classic English tying joint found in most First Period homes, and suggests that the Hawkins house might've been constructed later than claimed.
I've never seen this style of joint diagrammed in any of the early timber frame surveys I've studied. Several of my colleagues in the Timber Framers Guild's TTRAG told me they're not familiar with it either, and suggested it might very well be a design that originated in my local area. As I'd mentioned in a previous posting, the Reverend Richard Mansfield House, less than ten miles aways, employs an almost identical tying joint in its bent system.
June 2017 Desktop Calendar
3 weeks ago